NET/MASTER Messages Manual

NNM1102
Messages
2–228 106159 Tandem Computers Incorporated
your system manager. The manager should contact the Tandem support
representative, providing the following information:
NCL procedure that caused the error
Definition file of the panel that caused the error
TIMEOUT
An input-output operation timed out on the terminal. The NonStop
NET/MASTER MS system uses a timeout period of 30 seconds for each terminal
operation. A timeout situation may indicate other problems. For example:
The terminal was turned off. Turn the terminal back on.
The physical connection between the terminal and the system has become
faulty. Check the connection and correct any faults.
The operating system was unable to service an input-output request within
the timeout period. Refer the message to your system manager.
Effect. If the user was in a session, then the session aborts. If the user was logging on
from the TACL program, the TACL prompt appears. If the user issued an
OPENTERM command, the system tries to display the logon panel every two minutes.
Recovery. Use the error text to determine the appropriate action to take.
NNM1102 WILL RETRY EVERY 2 MIN ON TERMINAL logitermname devname
Cause. An OPENTERM command was issued but failed. The NonStop NET/MASTER
MS system will retry the command every two minutes. Subsequent retries will not
cause this message to appear.
logitermname is the logical name of the terminal being opened.
devname is the device name of the terminal being opened.
Effect. The OPENTERM command is retried every 2 minutes. The retry stops when
the terminal becomes available.
Recovery. When the OPENTERM command succeeds, message NNM1103 will appear.
You can use the CLOSTERM command to stop the periodical retry of the OPENTERM
command.