NET/MASTER Messages Manual

NNM1205
Messages
2–232 106159 Tandem Computers Incorporated
applstat is the status of the terminal. The status is one of the following:
IN SESSION indicates that a user is logged on.
SUSPENDED indicates that a user is using the PROGRUN
command.
WAIT LOGON indicates that the terminal is waiting for a user
to log on.
Effect. The information is retrieved and displayed.
Recovery. This message is informational only; no recovery action is necessary.
NNM1205 NO TERMINALS CONNECTED
Cause. A SHOW SESS=ALL or SHOW TERM=ALL command was issued but no
terminals were connected to the NonStop NET/MASTER MS system. The command
might be issued, for example, by a remote user or by a virtual user.
Effect. No connected terminals are found.
Recovery. This message is informational only; no recovery action is necessary.
NNM1206 termname NOT CONNECTED
Cause. A SHOW SESS=termname or SHOW TERM=termname command was issued to
obtain information about a terminal but the terminal is not connected to the NonStop
NET/MASTER MS system.
termname is either the logical name or the device name of the terminal.
Effect. The command is ignored.
Recovery. Use the SHOW TERMDEF=ALL command to list the logical and device
names of the terminals. The status of the terminal can be DISCONNECTED, NON_CONN,
or PENDING CONN.
If the status is DISCONNECTED or NON_CONN, you can use the OPENTERM command
to connect the terminal to the system and retry the command.
If the status is PENDING CONN, you do not need to take any action. You can retry the
command when the terminal is opened.