NET/MASTER Messages Manual

NNM1210
Messages
106159 Tandem Computers Incorporated 2–235
TERM BUF SIZE EXCEEDED
The terminal buffer became full while a panel was being displayed. A NonStop
NET/MASTER MS system uses an output buffer of about 4.1 KB (Tandem 6530
terminals) or 8 KB (IBM 3270 terminals) for panels. Reduce the number of fields in
the panel or disable color display to economize on the transferred data. If the
problem persists, the message indicates an internal error. Refer the message to
your system manager. The manager should contact the Tandem support
representative, providing the following information:
NCL procedure that caused the error
Definition file of the panel that caused the error
TIMEOUT
An input-output operation timed out on the terminal. The NonStop
NET/MASTER MS system uses a timeout period of 30 seconds for each terminal
operation. A timeout situation may indicate other problems. For example:
The terminal was turned off. Turn the terminal back on.
The physical connection between the terminal and the system has become
faulty. Check the connection and correct any faults.
The operating system was unable to service an input-output request within
the timeout period. Refer the message to your system manager.
Effect. The terminal is not connected. However, for TIMEOUT, the command is retried
every two minutes.
Recovery. Investigate the error and correct the problem before retrying the
OPENTERM command to connect the terminal.
NNM1210 NO DISCONNECTED TERMINALS TO CONNECT
Cause. An OPENTERM ALL command was issued but all defined terminals are
already connected to the NonStop NET/MASTER MS system. There were no
terminals for OPENTERM to connect.
Effect. The command is ignored.
Recovery. This message is informational only; no recovery action is necessary.