NET/MASTER Messages Manual

NNM1211
Messages
2–236 106159 Tandem Computers Incorporated
NNM1211 NO DISCONNECTED TERMINALS MEET GENERIC CRITERIA OF termmask
Cause. An OPENTERM or a TERMINAL DELETE command was issued using a mask
(a name ending in an *) to specify terminals. However, there were no disconnected
terminals with a name that matched the mask.
termmask is the specified mask.
Effect. The command is ignored.
Recovery. Use the SHOW TERMDEF=ALL command to list the logical and device
names of the terminals. Specify a correct mask and retry the command.
NNM1212 NO DISCONNECTED TERMINAL KNOWN AS termname
Cause. An OPENTERM or a TERMINAL DELETE command was issued for a terminal
that was known to the NonStop NET/MASTER MS system but was not in a
disconnected state (closed).
termname is either the logical name or the device name of the terminal.
Effect. The command is ignored.
Recovery. If you issued an OPENTERM command, no further action is required. The
terminal is already open.
If you issued a TERMINAL DELETE command, use the SHOW TERM command. If
the terminal is in the WAIT LOGON state, you can issue the CLOSTERM command to
close it and then issue the TERMINAL DELETE to delete it. Otherwise, consult with
the user currently logged on to that terminal before issuing the CLOSTERM command.
NNM1213 termname ALREADY CONNECTED
Cause. An OPENTERM command was issued to connect a terminal to the NonStop
NET/MASTER MS system but the terminal was connected to the system already.
termname is either the logical or the device name of the terminal.
Effect. The command is ignored.
Recovery. This message is informational only; no recovery action is necessary.