NET/MASTER Messages Manual

NNM1244
Messages
106159 Tandem Computers Incorporated 2–247
NNM1242 YOUR TOP-LEVEL NCL HAS BEEN TERMINATED
Cause. Your request to log on to the NonStop NET/MASTER MS system was
successful, but your top-level NCL procedure was terminated before your
environment was ready. The system may have shut down or another user may have
issued a FLUSH command that terminated your procedure.
Effect. The logon fails.
Recovery. If the system is not shutting down, log on to the system again. If the system
is shutting down, log on when the system comes up again.
NNM1243 YOUR TOP-LEVEL NCL COULD NOT BE LOADED BECAUSE OF 'MAXK'
Cause. Your request to log on to the NonStop NET/MASTER MS system was
successful, but the system could not load your top-level NCL procedure. There was
not enough memory for your NCL procedure to load.
Effect. The logon fails.
Recovery. Retry the logon. If the problem persists, refer the message to your system
manager. The manager may use the SYSPARMS NCLMAXK command to increase the
memory allocated to NCL processes.
NNM1244 UNSPECIFIED ERROR IN YOUR TOP-LEVEL NCL
Cause. Your request to log on to the NonStop NET/MASTER MS system was
successful, but an error occurred when the system started your top-level NCL
procedure.
Effect. The logon fails.
Recovery. If you have another user ID, log on with that ID. Check and correct your
procedure, or use a different top-level NCL procedure in your UMS profile for the ID
that caused the problem. Otherwise, refer the message to your system manager who
can change your top-level NCL procedure entry in the UMS. If the problem persists,
contact the Tandem support representative and provide the following information:
A copy of your top-level NCL procedure
The activity log