NET/MASTER Messages Manual

NNM1371
Messages
2–260 106159 Tandem Computers Incorporated
NNM1371 MORE THAN 90 #FLD ATTRIBUTE CHARACTERS SPECIFIED
Cause. The panel description file contained more than 90 different field attribute
characters. Only up to 90 different field attribute characters can be used in the same
file.
Effect. The panel is not displayed.
Recovery. Reduce the number of different field attribute characters in the description
file to 90, and restart the procedure.
NNM1372 INVALID INWAIT OPERAND SPECIFIED
Cause. The #OPT statement specified the INWAIT operand with an invalid value. The
value must be numeric and in the range 0 through 86400 seconds (24 hours).
Effect. The panel is not displayed.
Recovery. Use a correct value for the INWAIT operand in the panel description file,
and restart the procedure.
NNM1373 #OPT DEFAULT OPERAND SPECIFIES INVALID ATTRIBUTE CHARACTER(S)
Cause. The #OPT statement specified the DEFAULT operand with an invalid value.
The value must be three nonalphanumeric characters (except ampersand).
Effect. The panel is not displayed.
Recovery. Use a correct value for the DEFAULT operand in the panel description file,
and restart the procedure.
NNM1374 DEFAULT ATTRIBUTE CHARACTERS CONFLICT OR DUPLICATION
Cause. The #OPT statement specified the DEFAULT operand with new default field
characters. However, some of the characters duplicated the ones that were defined
already by #FLD statements. You cannot redefine the default field attribute characters
to those that are already defined in #FLD statements.
Effect. The panel is not displayed.
Recovery. Remove the duplication from the panel description file, and restart the
procedure.