NET/MASTER Messages Manual

NNM1562
Messages
106159 Tandem Computers Incorporated 2–299
NNM1560 process-name shutdown-command PROCEEDING
Cause. You used the NNM shutdown utility to issue an FSTOP or SHUTDOWN
command while the target NonStop NET/MASTER MS system was still initializing.
The command cannot be processed because the NonStop NET/MASTER MS control
process is not ready. The message indicates that shutdown is pending.
process-name is the name of the control process for the NonStop
NET/MASTER MS system to be shut down.
shutdown-command is either FSTOP or SHUTDOWN.
Effect. The FSTOP or SHUTDOWN command waits for the NonStop NET/MASTER
MS control process to be ready to process the command.
Recovery. If you want the shutdown to proceed, do nothing. If you want to abort the
shutdown, press the BREAK key (Tandem 6530 terminals) or the ATTN key (IBM 3270
terminals).
NNM1561 process-name shutdown-command ABORTED
Cause. You pressed the BREAK key (Tandem 6530 terminals) or the ATTN key (IBM
3270 terminals) and aborted the shutdown you requested through the NNM shutdown
utility. The shutdown has been pending, as indicated by the NNM1560 message.
process-name is the name of the control process for the NonStop
NET/MASTER MS system to be shut down.
shutdown-command is either FSTOP or SHUTDOWN.
Effect. The pending shutdown is aborted, and control is returned to the TACL
program.
Recovery. This message is informational only; no recovery action is necessary.
NNM1562 INVALID COMMAND command-text
Cause. You used an invalid command with the NNM shutdown utility.
command-text is the command used.
Effect. The command is rejected.
Recovery. Valid commands are FSTOP, SHUTDOWN, and SHUTDOWN $ABEND$.
Correct the command, and retry.