NET/MASTER Messages Manual

NNM1704
Messages
2–312 106159 Tandem Computers Incorporated
NNM1704 COMMAND REJECTED. LIMIT OF maxtmrcmd TIMER BASED COMMANDS
REACHED
Cause. An AT or EVERY command was issued but the NonStop NET/MASTER MS
system could not take on another timer command.
maxtmrcmd is the maximum number of active timers allowed.
Effect. The command is not queued for execution.
Recovery. Retry the command later. The system may have purged some timer
commands thus allowing new timer commands to run. Your system manager can
increase the allowed number of active timers through the TCMDMAX system
parameter.
NNM1705 'EVERY' COMMAND MINIMUM REPEAT TIME IS mintime SECONDS
Cause. An EVERY command was issued but the specified timer interval is less than the
displayed value ( mintime ) in seconds. The minimum interval is set through the
EVCMDMIN system parameter.
Effect. The command is not queued for execution.
Recovery. Specify a time interval greater than the minimum interval and retry the
command.
NNM1706 COMMAND ACCEPTED, PURGE ID NUMBER IS timer_number
Cause. An AT or EVERY command was issued and is now in action. The NonStop
NET/MASTER MS system used a purge ID ( timer_number ) to identify the
command.
Effect. The command is queued for execution at the specified time interval.
Recovery. This message is informational only; no recovery action is necessary.
NNM1707 'AT' COMMAND TIME RANGE IS 00:00:01 TO 24:00:00
Cause. An AT command was issued but an invalid time was specified.
Effect. The command is not queued for execution.
Recovery. Specify the correct time and retry the command.