NET/MASTER Messages Manual

NNM1859
Messages
2–328 106159 Tandem Computers Incorporated
NNM1859 COULD NOT START NCL PROC procname
Cause. You pressed an action key (function key of type ACT) but the associated NCL
procedure failed to start.
procname is the name of the procedure.
Effect. The procedure is not started.
Recovery. Use the FK command to list the action key and check the name of the
associated procedure:
If the name is incorrect, use the FK command to redefine the key.
If the name is correct, try to start the procedure from the OCS command line and
note any returned messages. Correct the procedure if necessary.
Press the action key to retry the operation.
NNM1860 KEY NOT SET. AT LEAST ONE KEY MUST EXECUTE COMMAND LINE TEXT.
Cause. The ENTER command was issued but no other function key was defined as a
replacement for an ENTER key.
Effect. The definition of the ENTER key is not changed.
Recovery. Define a key that can execute a command line text, for example, FK
PAGEUP IMM. Retry the command.
NNM1861 fnkey KEY SET
Cause. An FK command was issued to define a function key, and the operation was
successful.
fnkey is the name of the key.
Effect. The function key is defined.
Recovery. This message is informational only; no recovery action is necessary.