NET/MASTER Messages Manual

NNM1900
Messages
106159 Tandem Computers Incorporated 2–329
NNM1863 command COMMAND REJECTED. errtext
Cause. An ENTER, FK, or PF command was issued but failed.
errtext is one of the following:
NO PFK LIST FOUND
There is a memory shortage. Retry the command. If the problem persists, refer
the message to your system manager. The manager should try to recover disk
space from the swap volume.
CANNOT RESET GLOBAL ASSIGNMENT
An ENTER IMM command was issued in the INIT procedure. Remove the
command from the procedure.
AT LEAST ONE KEY MUST ACCEPT COMMAND LINE ENTRY
You tried to redefine a function key that was used as the only natural ENTER key.
Define another natural ENTER key and then redefine the function key.
Effect. The command fails.
Recovery. Use the error text to determine the appropriate action to take.
NNM1864 fnkey KEY RESET
Cause. An ENTER, FK, or PF command was issued to reset the ENTER key
assignment, and the operation was successful.
fnkey is the name of the ENTER key.
Effect. The ENTER key is reset.
Recovery. This message is informational only; no recovery action is necessary.
NNM1900 NCL nclid ALREADY BEING DEBUGGED dsession
Cause. A DEBUG START command was issued to start a debug session for an NCL
process but the NCL process is already being debugged by either the current debug
session or another debug session.
nclid is the ID of the NCL process specified.
dsession is null if debugged by current session or BY ANOTHER SESSION if
debugged by another session.
Effect. The NCL process remains in a debug session.
Recovery. This message is informational only; no recovery action is necessary.