NET/MASTER Messages Manual

NNM0061
Messages
106159 Tandem Computers Incorporated 2–23
NNM0061 UNIT NAME DEVICE MODE SIZE DELAY
Cause. A SHOW LINKS=linkname command was issued and the message is part of the
response. The line contains the headings for information about a unit. Other
messages provide the actual information.
UNIT NAME is the heading for the name of a unit.
DEVICE is the heading for the device name of the unit.
MODE is the heading for the mode of operation. The mode is one of the
following:
ACTV indicates an active switched virtual circuit (SVC) in an X.25
session.
PASS indicates a passive SVC in an X.25 session.
PERM indicates a permanent virtual circuit (PVC) in an X.25 session.
PRIM indicates a primary unit in a PTP or SNA session.
SECO indicates a secondary unit in a PTP or SNA session.
SIZE is the heading for the input-output size used by the unit in bytes.
DELAY is the heading for the connect delay in seconds.
Effect. The headings are displayed.
Recovery. This message is informational only; no recovery action is necessary.