NET/MASTER Messages Manual

NNM0062
Messages
2–24 106159 Tandem Computers Incorporated
NNM0062 unitname devname mode size delay
Cause. A SHOW LINKS=linkname command was issued and the message is part of the
response. The line contains information about a unit.
unitname is the name of the unit.
devname is the device name of the unit.
mode is the mode of operation. The mode is one of the following:
ACTV indicates an active switched virtual circuit (SVC) in an X.25
session.
PASS indicates a passive SVC in an X.25 session.
PERM indicates a permanent virtual circuit (PVC) in an X.25 session.
PRIM indicates a primary unit in a PTP or SNA session.
SECO indicates a secondary unit in a PTP or SNA session.
size is the input-output size used by the unit in bytes.
delay is the connect delay in seconds.
Effect. The information is retrieved and displayed.
Recovery. This message is informational only; no recovery action is necessary.
NNM0063 DTEADDR SESSION NAME
Cause. A SHOW LINKS=linkname command was issued and the message is part of the
response. The line contains the headings for information about a unit. Other
messages provide the actual information.
DTEADDR is the heading for the data-terminal equipment (DTE) address
(analogous to a telephone number) of the called party.
SESSION NAME is the heading for the name of the session using the unit.
Effect. The headings are displayed.
Recovery. This message is informational only; no recovery action is necessary.