NET/MASTER Messages Manual

NNM2170
Messages
106159 Tandem Computers Incorporated 2–391
NNM2167 COMMAND SET IS NOT DEFINED
Cause. An attempt was made to browse, copy, update, delete, or run a command set
definition that was not there.
Effect. The request is not performed.
Recovery. If the name or type was entered incorrectly, correct it and try again.
If the name and type were entered correctly, and you were deleting, the definition is
already deleted.
NNM2168 'SAME AS' COMMAND SET IS NOT DEFINED
Cause. The “Same as” field names a utility for which no command set has been
defined. Note that the type of the command set being referenced is assumed to be the
same as the type of the command set being entered or updated.
Effect. The definition is not added or updated.
Recovery. Specify an existing utility name in the “Same as” field and retry the
operation. Remember that a type O command set can only refer to another type O
command set, and a type P command set can only refer to another type P command
set.
NNM2169 COMMANDS NOT ALLOWED WITH 'SAME AS'
Cause. Both the “Same as” field and one or more command fields were completed.
Effect. The definition is not added or updated.
Recovery. Either erase the 'Same as' field or erase all the command fields and try again.
NNM2170 EITHER COMMANDS OR 'SAME AS' MUST BE SPECIFIED
Cause. An attempt was made to add or update a command set definition that specified
neither command authorities nor a “Same as” utility.
Effect. The definition is not added or updated.
Recovery. Specify a command list or a “Same as” utility and try again.