NET/MASTER Messages Manual

NNM2204
Messages
106159 Tandem Computers Incorporated 2–403
NNM2201 MSGPROC NOT ACTIVE, FLUSH REQUEST REJECTED
Cause. The cause is one of the following:
1. A PROFILE MSGPROC=FLUSH command was issued, but the attempt to flush
MSGPROC failed because no MSGPROC was running.
2. A PROFILE MSGPROC=procname command was issued, but the specified NCL
procedure did not exist.
Effect. The request is rejected.
Recovery. For cause 1, this message is informational only and no recovery action is
necessary.
For cause 2, reissue the command using the correct name of a MSGPROC NCL
procedure that exists in your NCL procedure search path.
NNM2202 MSGPROC FLUSHED
Cause. A PROFILE MSGPROC=FLUSH command was issued, and the attempt to
flush MSGPROC was successful.
Effect. MSGPROC processing is terminated.
Recovery. This message is informational only; no recovery action is necessary.
NNM2203 NCL REGION DOES NOT SUPPORT MSGPROC PROCESSING
Cause. A PROFILE MSGPROC=procname command was issued but the attempt to start
the NCL procedure (procname) failed because the environment did not support the
use of MSGPROC. Only an OCS environment supports the use of MSGPROC.
Effect. The procedure is not started.
Recovery. Do not start MSGPROC in this environment.
NNM2204 CANNOT OPEN MORE THAN 2 WINDOWS
Cause. A SPLIT command was issued at the OCS command line while there were
already two active OCS windows.
Effect. The command is rejected.
Recovery. If it is necessary to adjust the size of the existing windows, press F2.