NET/MASTER Messages Manual

NNM2358
Messages
2–410 106159 Tandem Computers Incorporated
NNM2358 ONLY '*' ALLOWED FOR PROGRUN UTILITY
Cause. For a PROGRUN utility, the command set definition may contain only an *
entry for the Command field. Checks of the user's authority for individual commands
cannot be done for PROGRUN utilities. The only check that may be done is to
determine whether the user may run the utility at all.
Effect. The definition cannot be updated or added.
Recovery. If the utility is a PROGRUN utility, specify * in the Command field. If the
utility is really an OPSYS utility, change the utility type.
NNM2359 CANNOT operand ENTRY FOR key . VARTABLE ERROR n
Cause. The NCL procedure encountered an error on a vartable used in executing the
command.
operand is the operand of the VARTABLE verb that failed.
key is the name of the key specified.
n is the return code from the VARTABLE verb.
This is an internal error in the NCL procedure performing the command.
Effect. If the error occurred while processing an OPSYS command, the command is not
executed.
If the error occurred while updating or adding a command set, and if the FILE
command or function key triggered the message, the command set is not updated or
added.
Recovery. If the NCL procedure encountering the error has been customized, examine
the changes carefully. If the NCL has not been customized and if the error code does
not indicate a problem you can resolve, contact your Tandem support representative.
NNM2360 DUPLICATE COMMAND
Cause. A command name appeared more than once in the command set definition.
For a large set of commands, one of the duplicates might be off the panel.
Effect. The definition cannot be updated or added.
Recovery. Eliminate all but one of the duplicates.