NET/MASTER Messages Manual

NNM2364
Messages
106159 Tandem Computers Incorporated 2–411
NNM2361 TOO MANY COMMANDS IN THE COMMAND SET
Cause. A command set definition had more than 140 commands.
Effect. The definition cannot be updated or added.
Recovery. Reduce the number of commands specified.
NNM2362 UTILITY TYPE INCOMPATIBLE WITH VALUES ON THE OTHER PANEL
Cause. You changed the utility type on one of the Utility Details panels, but there were
already entries on the other panel that are not permitted for the new type. The set of
values on both panels must always be consistent with each other.
Effect. The definition cannot be updated or added.
Recovery. If the utility type change was an accident, correct it and proceed. If you do
want to change the utility type, temporarily put it back to the original type, go to the
first panel, erase the offending entries, then change the utility type and proceed.
NNM2363 INVALID MACRO NAME
Cause. The macro name entered is neither a valid Guardian file name nor a valid
TACL variable name. A Tandem file name must be fully qualified, except that the
system name may be omitted. A TACL variable name may have qualifying directory
names with colon separators.
Effect. The definition cannot be updated or added.
Recovery. The name is most likely mistyped; correct the spelling and try again. If the
name is as you intended, check your source to find the correct name.
NNM2364 MUST SPECIFY LENGTH WITH ENDING CHARACTER
Cause. An end character for the prompt was specified without specifying a
corresponding length. In defining the end prompt character, you must also specify
how long the prompt can be.
Effect. The definition cannot be updated or added.
Recovery. Either supply a length or erase the “Ending with this character” field.