NET/MASTER Messages Manual

NNM2372
Messages
2–414 106159 Tandem Computers Incorporated
NNM2372 NETSTATUS MUST BE RUN FROM NETSTAT
Cause. The NetStatus utility requires further communication after the PROGRUN
command is issued. The extra communication requirements are met in the NETSTAT
NCL routine, which should be used to invoke the NetStatus utility.
Effect. The NetStatus utility is not invoked.
Recovery. Use the command NETSTAT (or START NETSTAT) rather than PROGRUN
NETSTATUS.
NNM2373 'SAME AS' CANNOT REFER TO ITS OWN COMMAND SET
Cause. The “Same as” field of a command set definition may not specify itself. The
"Same as" field enables a utility definition to use the set of commands and authorities
defined for another utility.
Effect. The definition cannot be updated or added.
Recovery. Either supply the name of another, existing command set, or leave the
“Same as” field empty, and enter command names and authorities.
NNM2374 UTILITY DEFINITION name type ADDED
Cause. An Add or Copy operation was completed successfully. The utility name and
type appear in the message.
Effect. The utility definition is added.
Recovery. This message is informational only; no recovery action is necessary.
NNM2450 PATHMON process_name IS NOT RUNNING
Cause. An attempt was made to invoke a Pathway application when its PATHMON
process was not up and running.
process_name is the name of the PATHMON process.
Effect. The application session is not established.
Recovery. Bring up the application's PATHWAY environment, and invoke the
application again.