NET/MASTER Messages Manual

NNM2560
Messages
106159 Tandem Computers Incorporated 2–421
NNM2558 ISR LINK WAS NOT ENABLED FOR OUTBOUND EMS TRAFFIC
Cause. You specified an INMC link that was not enabled for outbound EMS event
messages when you pressed the DSM/PM Interface action function key to send an
EMS event to DSM/PM.
Effect. No DSM/PM record is added.
Recovery. Use the SHOW ISR command to get the ISR configuration of your link. If
the link is not enabled for ISR conversations, issue the ISR ENABLE=EMS
LINK=link-name UNSOLICITED=OUTBOUND command to allow outbound EMS
traffic on the link. If the link is enabled for ISR conversations, use the ISR ALTER
command to alter the ISR configuration of the link to allow outbound EMS traffic.
NNM2559 STORAGE SHORTAGE - EVENT NOT SENT
Cause. You pressed the DSM/PM Interface action function key to send an EMS event
to DSM/PM, but memory shortage prevented the event from being sent.
Effect. No DSM/PM record is added.
Recovery. Wait a few minutes, then try to resend the event. If repeated attempts fail,
find out from your system manager when the memory problem will be rectified.
NNM2560 ISR QUEUE OVERFLOW - EVENT NOT SENT
Cause. You pressed the DSM/PM Interface action function key to send an EMS event
to DSM/PM, but a full ISR queue prevented the event from being sent.
Effect. No DSM/PM record is added.
Recovery. Wait a few minutes, then try to resend the event. If repeated attempts fail,
check the NonStop NET/MASTER activity log for messages that indicate problems
with the INMC link.