NET/MASTER Messages Manual

NNM2561
Messages
2–422 106159 Tandem Computers Incorporated
NNM2561 EMS COLLECTOR NOT STARTED, INSUFFICIENT TOKENS OR GUARDIAN SPI
ERROR
Cause. You pressed the DSM/PM Interface action function key to send an EMS event
to DSM/PM, but one of the following reasons prevented the event from being sent:
1. The EMS collector was not started.
2. The message MDO passed did not contain the minimum number of required SPI
tokens. This should only occur for user-generated events that were raised by the
EMSALERT verb.
3. An EMS Guardian procedure returned an SPI error.
Effect. No DSM/PM record is added.
Recovery. Take appropriate action according to the cause as follows:
1. Use the STATUS command to check that the EMS collector is started. If the
collector is not started, issue the EMSCOLL START command. If you do not have
the authority to use the EMSCOLL START command, refer the message to your
system manager.
2. Refer the message to your system programmer. The programmer should locate
the source of the event and ensure that the EMSALERT verb is correctly used.
3. A severe error has occurred. Contact your Tandem support representative.
NNM2562 INPUT ERROR - error-text
Cause. You pressed the DSM/PM Interface action function key to send an EMS event
to DSM/PM, but an error prevented the event from being sent.
error-text is a NonStop NET/MASTER MS message that indicates the
cause of the error.
Effect. No DSM/PM record is added.
Recovery. Use error-text to determine the appropriate action to take.