NET/MASTER Messages Manual

NNM2564
Messages
2–424 106159 Tandem Computers Incorporated
NNM2564 DSM/PM ERROR: error-text
Cause. An error occurred when you pressed the DSM/PM Interface action function
key to send an event to DSM/PM.
error-text gives the reason of the error as follows:
NO MDO WAS PASSED
Your cursor was on a message that did not contain an MDO. The message is not
an EMS event message.
NO SPI TOKENS WERE FOUND IN THE MDO
Your cursor was on a message that did not contain any SPI tokens. The message is
not an EMS event message.
PARAMETER n IS INVALID
A parameter string on your command line is invalid. Blanks separate the
parameter strings on your command line. n is a number that gives the position of
the parameter string that was in error.
TOO MANY DESTINATIONS WERE SPECIFIED
You specified more than one destination on your command line.
KEYWORD text-string NOT SUPPORTED
Your command line contained the invalid keyword text-string .
Effect. No DSM/PM record is added.
Recovery. For NO MDO WAS PASSED and NO SPI TOKENS WERE FOUND IN THE
MDO, you cannot send the selected message to DSM/PM.
For all other causes, your command line must contain one of the following:
Nothing
DOMAIN= domainid
LINK= linkname
NNM2600 HOST CONFIGURATION PARAMETERS
Cause. A SHOW SESS or SHOW TERM command using the DETAIL=YES or
DETAIL=OPEN operand was issued, and the message is part of the response. The line
contains the heading for the host configuration parameters for the terminal.
Effect. The heading is displayed.
Recovery. This message is informational only; no recovery action is necessary.