NET/MASTER Messages Manual

NNM2602
Messages
106159 Tandem Computers Incorporated 2–425
NNM2601 parameter-1 parameter-2
Cause. A SHOW SESS or SHOW TERM command with the DETAIL=YES or
DETAIL=OPEN operand was issued, and the message is part of the response. The line
contains information about the host configuration parameters for the terminal in two
columns.
parameter-1 contains the name and value of a host configuration parameter.
parameter-2 contains the name and value of a host configuration parameter
or blank.
Effect. The information is retrieved and displayed.
Recovery. For further information, refer to SETMODE in the Guardian Procedure Calls
Reference Manual.
If the information about a parameter appears in the form parameter-name: N/A, the
parameter is either not supported or not available from the Tandem I/O process that
controls the targeted terminal. Refer the message to your system manager, who
should contact the Tandem support representative, identifying the terminal type and
any terminal emulation software used.
If the information about a parameter appears in the form parameter-name: UNKNOWN
VALUE parameter-value, the value of the parameter is unknown to NonStop
NET/MASTER MS. Refer the message to your system manager. The system manager
should contact the Tandem support representative, identifying the terminal type and
any terminal emulation software used.
NNM2602 TERMINAL FIRMWARE INFORMATION
Cause. A SHOW SESS or SHOW TERM command with the DETAIL=YES or
DETAIL=OPEN operand was issued, and the message is part of the response. The line
contains the heading for the firmware information about the terminal.
Effect. The heading is displayed.
Recovery. This message is informational only; no recovery action is necessary.