NET/MASTER Messages Manual

NNM2603
Messages
2–426 106159 Tandem Computers Incorporated
NNM2603 fware-val1 fware-val2
Cause. A SHOW SESS or SHOW TERM command with the DETAIL=YES or
DETAIL=OPEN operand was issued and the message is part of the response. The line
contains the firmware information about the terminal in two columns.
fware-val1 contains a piece of firmware information.
fware-val2 contains a piece of firmware information or blank.
Effect. The information is retrieved and displayed.
Recovery. This message is informational only; no recovery action is necessary.
NNM2604 TERMINAL STATUS
Cause. A SHOW SESS or SHOW TERM command with the DETAIL=YES or
DETAIL=OPEN operand was issued, and the message is part of the response. The line
contains the heading for the status information about the terminal and attached
devices.
Effect. The heading is displayed.
Recovery. This message is informational only; no recovery action is necessary.
NNM2605 status-value
Cause. A SHOW SESS or SHOW TERM command with the DETAIL=YES or
DETAIL=OPEN operand was issued, and the message is part of the response. The line
contains the status of a feature of the terminal.
status-value identifies the feature and displays its status.
Effect. The information is retrieved and displayed.
Recovery. This message is informational only; no recovery action is necessary.
For further information about terminal types, refer to the programmer's guide . The
terminal type appears under NNM2602 TERMINAL FIRMWARE INFORMATION.