NET/MASTER Messages Manual

NNM2608
Messages
106159 Tandem Computers Incorporated 2–427
NNM2606 TERMINAL CONFIGURATION PARAMETERS
Cause. A SHOW SESS or SHOW TERM command with the DETAIL=YES or
DETAIL=OPEN operand was issued, and the message is part of the response. The line
contains the heading for the configuration parameters for the terminal.
Effect. The heading is displayed.
Recovery. This message is informational only; no recovery action is necessary.
NNM2607 config-val1 config-val2
Cause. A SHOW SESS or SHOW TERM command with the DETAIL=YES or
DETAIL=OPEN operand was issued, and the message is part of the response. The line
contains information about the configuration parameters for the terminal in two
columns.
config-val1 contains the name and value of a configuration parameter.
config-val2 contains the name and value of a configuration parameter or
blank.
Effect. The information is retrieved and displayed.
Recovery. For further information about terminal types, refer to the programmer's
guide. The terminal type appears under NNM2602 TERMINAL FIRMWARE
INFORMATION.
If the information about a parameter appears in the form UNKNOWN CODE:
parameter-code VALUE: parameter-value, the parameter is unknown to NonStop
NET/MASTER MS. If the information about a parameter appears in the form
parameter-name : UNKNOWN VALUE: parameter-value, the value of the parameter is
unknown to NonStop NET/MASTER MS. In either case, refer the message to your
system manager. The system manager should contact the Tandem support
representative, identifying the terminal type and any terminal emulation software
used.
NNM2608 DEVICE INFORMATION
Cause. A SHOW SESS or SHOW TERM command with the DETAIL=YES or
DETAIL=OPEN operand was issued, and the message is part of the response. The line
contains the heading for the device information about the terminal.
Effect. The heading is displayed.
Recovery. This message is informational only; no recovery action is necessary.