NET/MASTER Messages Manual

NNM2850
Messages
106159 Tandem Computers Incorporated 2–439
NNM2806 process-name q-number current-msgs / max-msgs 0x creator-thrd
0x reader-thrd
Cause. A SHOW QUEUES command was issued, and the message is part of the
response. The line contains information about queue usage that may be useful to
Tandem support representatives.
process-name is the name of the process.
q-number is the identifier of the queue.
current-msgs is the number of messages currently queued.
max-msgs is the maximum number of messages queued.
creator-thrd is the thread ID (in hexadecimal format) of the thread that
created the queue.
reader-thrd is the thread ID (in hexadecimal format) of the thread that most
recently read the queue.
Effect. The information about queues is retrieved and displayed.
Recovery. This message is informational only; no recovery action is necessary.
NNM2850 CUSTOM AND DISTRIBUTED HELP DATABASES ARE NOT OPENED AS A PAIR
Cause. A command help maintenance operation failed because the command help
database was not opened as a UDB pair by using the customized and the distributed
command help files.
Effect. The operation is not performed.
Recovery. Issue the SHOW UDB command. Proceed as follows, according to the
displayed information:
If the displayed list contains only one file with the ZHLPDB file ID:
a. Use FUP to create a customized command help file.
b. Use the UDBCTL CLOSE command to close the ZHLPDB UDB.
c. Use the UDBCTL OPEN command to open the customized and the distributed
command help files as a UDB pair, using ZHLPDB as the ID.
If the displayed list does not contain a file with the ZHLPDB file ID:
a. Use FUP to create a customized command help file.
b. Use the UDBCTL OPEN command to open the customized and the distributed
command help files as a UDB pair, using ZHLPDB as the ID.