NET/MASTER Messages Manual
NNM0078
Messages
2–32 106159 Tandem Computers Incorporated
NNM0078 DOMAIN ID REJECTED, LINK=
linkname
, LOCALDID=
ldomainid
,
REMOTEDID=
rdomainid
Cause. It was not possible to start an INMC link with a remote system because the
remote system had rejected the domain ID used for this NonStop NET/MASTER MS
system.
linkname
is the name of the INMC link.
ldomainid
is the domain ID of this NonStop NET/MASTER MS system.
rdomainid
is the domain ID of the remote system.
Effect. The link is considered faulty and cannot be used. The link status is
unpredictable. It will continue to be shown as PENDING-ACT on a SHOW LINKS
display.
Recovery. A NonStop NET/MASTER MS system will not reject a domain ID, so this
problem only occurs when connecting to SOLVE compatible systems running on other
hardware platforms. Check the documentation for the system to which you are
attempting to connect, and resolve the domain ID problem in consultation with the
staff responsible for configuring the remote system. If necessary, change the domain
ID. Issue LINK RESET and LINK START to bring the link into use once the problem is
resolved.
NNM0080 INMC UNEXPECTED MESSAGE FOR CONV
convhalfid1
convhalfid2
ON
LINK
linkname
Cause. This message is logged when an INMC data message is received on a
conversation that is thought to be inactive. This can occur when a data message was in
transit at the time the INMC link in question was stopped or reset.
convhalfid1
and
convhalfid2
are ID numbers that identify the conversation to the INMC programs.
convhalfid1
is an internal INMC conversation ID number.
convhalfid2
is an internal INMC conversation ID number.
linkname
is the name of the INMC link.
Effect. The link remains inactive and the unexpected message is ignored.
Recovery. If the problem occurred in isolation for an INMC link that has just been
stopped or reset, then it can be ignored since it was due to a message that was in
transit at the time and no recovery is necessary.
If the problem occurred when the link was not just stopped or reset, then take an SCF
trace of the line while the problem is occurring and also make a note of the two
conversation ID numbers that were displayed in the message. Then contact your
Tandem support representative.