NET/MASTER Messages Manual

NNM2917
Messages
2–456 106159 Tandem Computers Incorporated
NNM2917 VALUE SPECIFIED FOR TRANSID OPERAND WAS TOO LONG -
transaction-id
Cause. An OPSC command was issued, but the value specified for the TRANSID
operand was longer than 32 characters. The command was one of DEFTRANS,
REPTRANS, DELTRANS, or SHOW DEFTRANS.
transaction-id is the value specified for the TRANSID operand. This operand
specifies the OPSC transaction identifier.
Effect. The command is rejected.
Recovery. Replace the value with a shorter transaction ID, and retry the command.
NNM2919 TRANSACTION CONTROL TABLE ENTRY command-action
Cause. A DEFTRANS, REPTRANS, or DELTRANS command was issued and was
successful.
command-action is the actual operation on the Transaction Control Table (TCT)
entry, which occurred as a result of the command being issued,
as follows:
DEFINED indicates that a new TCT entry was added.
REPLACED indicates that an existing TCT entry was
replaced.
DELETED indicates that an existing TCT entry was deleted.
Effect. The operation is completed.
Recovery. This message is informational only; no recovery action is necessary.