NET/MASTER Messages Manual

NNM2932
Messages
106159 Tandem Computers Incorporated 2–461
NNM2930 MODE CONTROL TABLE ENTRY command-action
Cause. A DEFMODE, REPMODE or DELMODE command was issued and was
successful.
command-action is the actual operation on the Mode Control Table (MCT) entry,
which occurred as a result of the command being issued, as
follows:
DEFINED indicates that a new MCT entry was added.
REPLACED indicates that an existing MCT entry was
replaced.
DELETED indicates that an existing MCT entry was
deleted.
Effect. The operation is completed.
Recovery. This message is informational only; no recovery action is necessary.
NNM2931 MODE CONTROL TABLE ENTRY ALREADY EXISTS
Cause. A DEFMODE command was issued to define a mode, but a Mode Control
Table (MCT) entry with the specified mode name already existed.
Effect. The mode definition is not added to the MCT.
Recovery. Use the SHOW DEFMODE command to list all the entries in the MCT.
Change the mode name specified with the MODE operand to one that does not appear
in the list, and retry the command.
Alternatively, use the REPMODE command instead of the DEFMODE command. This
method replaces the existing entry in the MCT with one defined by the specified
parameters.
NNM2932 MODE CONTROL TABLE ENTRY NOT FOUND
Cause. A DELMODE command was issued to delete a mode definition, but no Mode
Control Table (MCT) entry with the specified mode name existed.
Effect. The command is rejected.
Recovery. Use the SHOW DEFMODE command to list all the entries in the MCT.
Change the mode name specified with the MODE operand to one that appears in the
list, and retry the command.