NET/MASTER Messages Manual

NNM2938
Messages
106159 Tandem Computers Incorporated 2–463
NNM2936 OPTION SET CONTROL TABLE ENTRY command-action
Cause. A DEFOPSET, REPOPSET, or DELOPSET command was issued and was
successful.
command-action is the actual operation on the Option Set Control Table (OSCT)
entry, which occurred as a result of the command being issued,
as follows:
DEFINED indicates that a new OSCT entry was added.
REPLACED indicates that an existing OSCT entry was
replaced.
DELETED indicates that an existing OSCT entry was
deleted.
Effect. The operation is completed.
Recovery. This message is informational only; no recovery action is necessary.
NNM2937 OPTION SET CONTROL TABLE ENTRY ALREADY EXISTS
Cause. A DEFOPSET command was issued to define an option set, but an Option Set
Control Table (OSCT) entry with the specified option set name already existed.
Effect. The option set definition is not added to the OSCT.
Recovery. Use the SHOW DEFOPSET command to list all the entries in the OSCT.
Change the option set name specified with the OPSET operand to one that does not
appear on the list, and retry the command.
Alternatively, use the REPOPSET command instead of the DEFOPSET command. This
method replaces the existing entry in the OSCT with one defined by the specified
parameters.
NNM2938 OPTION SET CONTROL TABLE ENTRY NOT FOUND
Cause. A DELOPSET command was issued to delete an option set definition, but no
Option Set Control Table (OSCT) entry with the specified option set name existed.
Effect. The command is rejected.
Recovery. Use the SHOW DEFOPSET command to list all the entries in the OSCT.
Change the option set name specified with the OPSET operand to one that appears in
the list, and retry the command.