NET/MASTER Messages Manual

NNM2944
Messages
106159 Tandem Computers Incorporated 2–465
NNM2941 NO ENTRIES FOUND IN OPTION SET CONTROL TABLE
Cause. A SHOW DEFOPSET command was issued, but no entries existed in the OPSC
Option Set Control Table (OSCT).
Effect. No OSCT entries are displayed.
Recovery. This message is informational only; no recovery action is necessary.
NNM2942 INVALID MODE LIST SPECIFIED FOR MODE OPERAND - operand-value
Cause. A DEFOPSET or REPOPSET command was issued, but the MODE operand
specified an invalid mode list. The list must be a single mode name, or a list of mode
names separated by commas and surrounded by parentheses: for example,
MODE=mode-name or MODE=(mode-name-1,mode-name-2,mode-name-3). A maximum
of four mode names may be specified in the list.
operand-value is the value specified for the MODE operand. This operand
specifies mode names.
Effect. The command is rejected.
Recovery. Correct the value, and retry the command.
NNM2943 TOO MANY VALUES IN MODE LIST SPECIFIED FOR MODE OPERAND
Cause. A DEFOPSET or REPOPSET command was issued, but the number of mode
names specified for the MODE operand exceeded the maximum of four.
Effect. The command is rejected.
Recovery. Remove enough mode names from the mode list specified with the MODE
operand to leave a maximum of four items in the list, and retry the command.
NNM2944 INVALID NULL ENTRY IN MODE LIST SPECIFIED FOR MODE OPERAND
Cause. A DEFOPSET or REPOPSET command was issued, but the mode list specified
for the MODE operand contained a null entry, which is invalid.
Effect. The command is rejected.
Recovery. Remove any comma (,) directly followed by another comma or an end
parenthesis ()) in the mode list specified with the MODE operand, and retry the
command.