NET/MASTER Messages Manual

NNM0089
Messages
2–36 106159 Tandem Computers Incorporated
NNM0089 INMC ACCESS METHOD type DOES NOT CORRESPOND TO DEFINITION OF
LINK= linkname UNIT= unitname
Cause. This message appears after a LINK START command was issued. The INMC
software was validating the configuration of the link that it was asked to start. It
found that the type of the device specified in the DEVICE setting of the unit definition
was not consistent with the TYPE setting of the session definition under which the unit
was configured.
For example, the name of an X.25 device was given in a unit definition, but the unit
was configured under an SNALU0 session.
type is the type of the session: PTP, SNALU0, or X25.
linkname is the name of the INMC link to be started.
unitname is the name of the unit that was incorrectly defined.
Effect. The INMC subsystem suspends any processing for the unit. Other units are
allowed to start if their configurations are correctly entered.
Recovery. To use all the units defined for the link, use the LINK RESET command to
reset the link. Correct the unit definitions, then use the LINK START command to
restart the link.
NNM0090 INMC LINK linkname ALREADY ENABLED,START COMMAND IGNORED
Cause. A LINK START command was issued but the INMC link was already started.
linkname is the name of the link specified.
Effect. The LINK START command is ignored and the state of the link is unchanged.
Recovery. This message is informational only; no recovery action is necessary.
NNM0091 INMC LINK linkname NOT ACTIVE
Cause. A LINK STOP command was issued but the INMC link was already stopped or
never started.
linkname is the name of the link specified.
Effect. The LINK STOP command is ignored and the state of the link is unchanged.
Recovery. This message is informational only; no recovery action is necessary.