NET/MASTER Messages Manual

NNM0101
Messages
106159 Tandem Computers Incorporated 2–37
NNM0100 INITIALIZATION FAILED ON LINK= linkname , DEVICE= devname
Cause. The INMC SNALU0 software received a message that is not an INMC protocol
message. This message commonly appears when an attempt is made to connect to a
remote SOLVE system, but the remote system assumes that it is communicating with a
3270 terminal and sends a 3270 data stream.
linkname is the name of the INMC link.
devname is the name of the device.
Effect. The INMC software will continue its attempts to establish proper contact with
the remote system either until the contact is established or until a LINK STOP or LINK
RESET command is issued.
Recovery. If the message appears while attempting to communicate with the SOLVE
software on the remote system, issue a LINK START command on the remote system.
This normally enables the connection to succeed.
For other cases, validate that the remote system supports the INMC protocol and that
it is connected through the correct physical devices on both ends of the link.
If the problem persists, take an SCF trace and report the matter to your Tandem
support representative. You must also provide a copy of the link configuration, and
your SCF and SYSGEN configuration of the relevant line(s) and device(s).
NNM0101 INMC SNALU0 SENSE sense1 sense2 , LINK= linkname , DEVICE= devname
Cause. This is an SNALU0 communications problem. Two sense codes were received
indicating an SNA event occurred.
sense1 is one of the two sense codes received.
sense2 is one of the two sense codes received.
linkname is the name of the INMC link.
devname is the name of the device.
Effect. The LU-LU session will be terminated but the INMC software will attempt to
reestablish it.
Recovery. No recovery is required unless the problem is persistent. Refer to the
meaning of the sense codes, and determine the appropriate action to take.