NET/MASTER Messages Manual

NNM0102
Messages
2–38 106159 Tandem Computers Incorporated
NNM0102 PACING INDICATORS IN BIND NOT SUPPORTED, LINK= linkname
DEVICE= devname
Cause. A LINK START command was issued and the INMC software is attempting to
establish an LU-LU session with the remote system. The remote system has indicated
in its BIND message that it wishes to use pacing, however the INMC software does not
support pacing.
linkname is the name of the INMC link being started.
devname is the name of the device.
Effect. The BIND message from the remote system is refused and the link cannot be
established.
Recovery. The remote system must be configured so that it does not request pacing.
Establishment of the link will then be automatic.
NNM0103 INMC LU0 INCORRECT APPLICATION NAME IN BIND. RCVD= aname
EXP= ename , LINK= linkname , DEVICE= devname , UNIT= unitname
Cause. A LINK START command was issued and the INMC software is attempting to
establish an LU-LU session with the remote system. The remote system has issued a
BIND message but the APPLID value in the BIND message does not match the
APPLID value configured in the session definition on this NonStop NET/MASTER
MS system.
aname is the APPLID value (remote application name) in BIND.
ename is the APPLID value in the local session definition.
linkname is the name of the INMC link being started.
devname is the name of the device.
unitname is the name of the unit.
Effect. The BIND message from the remote system is refused and the link is not
established.
Recovery. Ensure that both systems use the same APPLID value by changing one of the
two. Reset and restart the link using the LINK RESET and LINK START commands
once the APPLID values are correct.