NET/MASTER Messages Manual

About This Manual
106159 Tandem Computers Incorporated vii
Purpose This manual describes the NonStop NET/MASTER messages and Network Control
Language (NCL) error codes. The manual provides you with information on what
recovery actions to take when an error occurs.
Who Should Read This
Manual
Any NonStop NET/MASTER user may need to use this manual. You should refer to
this manual for further information when you receive a NonStop NET/MASTER
message.
How This Manual Is
Organized
This manual contains four sections, as follows:
Section 1, “Introduction,” provides:
Information on topics in this manual that require you to refer to other manuals
Information on what you should have ready if a problem requires you to
contact your Tandem support representative
Section 2, “Messages,” describes the NonStop NET/MASTER messages and
provides pertinent recovery actions.
Section 3, “NCL Error Codes,” describes the codes that appear as part of some
NonStop NET/MASTER messages.
Section 4, “Event-Message Tokens,” describes the event messages, and the
associated tokens, raised by NonStop NET/MASTER as Event Management
Service (EMS) events.
Where to Go for More
Information
Other manuals about the NonStop NET/MASTER products include the following:
NonStop NET/MASTER MS System Management Guide
NonStop NET/MASTER MS Operator’s Guide
NonStop NET/MASTER MS Command Reference Manual
NonStop NET/MASTER NCL Programmer’s Guide
NonStop NET/MASTER NCL Reference Manual
In addition to the NonStop NET/MASTER manuals, you might need to refer to the
following Tandem manuals:
Data Definition Language (DDL) Reference Manual
DSMS Systems Management Guide
EMS Manual
Guardian Procedure Calls Reference Manual
Guardian Procedure Errors and Messages Manual
Pathway Application Programming Guide
Safeguard User’s Guide
SPI Programming Guide
Subsystem Control Facility (SCF) Reference Manual
User’s Guide to DSNM Commands