NET/MASTER Messages Manual

NNM0354
Messages
106159 Tandem Computers Incorporated 2–81
NNM0352 ( indent ) MULTILINE MESSAGES WILL BE INDENTED BY num COLUMNS.
Cause. A PROFILE command was issued, and the message is part of the response. The
line contains information about the INDENT operand. INDENT specifies the number
of columns by which lines following the first line in a multiline message should be
indented.
indent is the value of the operand: 0 through m, where m is the width of the
terminal screen minus ten.
num is the number of columns to indent lines after the first line.
For example:
(INDENT=5....) MULTILINE MESSAGES WILL BE INDENTED BY 5
COLUMNS.
Effect. The information about INDENT is retrieved and displayed.
Recovery. This message is informational only; no recovery action is necessary.
NNM0353 num delim command
Cause. A HISTORY command was issued and the message is part of the response. The
line displays a command in the command history buffer.
num is the command reference number in the history buffer.
delim is the delimiter separating the number from the text.
command is the command text.
Effect. The information is retrieved and a command in the buffer is displayed.
Recovery. This message is informational only; no recovery action is necessary.
NNM0354 INVALID COMMAND REFERENCE NUMBER
Cause. A !, ?, FC, or HISTORY command was issued but specified an invalid command
reference number. You used either 0 or a reference number that was not associated
with any command.
Effect. The command is ignored.
Recovery. Specify a number other than 0 with a HISTORY command. With a !, ?, or FC
command, use HISTORY to list the commands in the buffer. Specify the reference
number for the required command and retry.