NET/MASTER Network Control Language (NCL) Programmer's Guide

Debugging an NCL Process From Start to Finish
Debugging an NCL Process
9–76 106160 Tandem Computers Incorporated
Resume execution to the next breakpoint, by using the DEBUG RESUME command, as
shown in the following screen.
(07:12) --------------------- OPERATOR CONTROL SERVICES ----------------------
DEBUG SOURCE
NNM1926 NCL 000670 LINE# SMT EV ON STMT-TEXT FROM ZEX0904N
NNM1927 NCL 000670 55 47 12 0 IF &LINELENGTH%7=0
NNM0999 *END*
DEBUG DISPLAY V=LINE V=LINELENGTH V=DAYS V=DAY V=FIRST
NNM1921 NCL 000670 VBL LINE VAL " 2 "
NNM1921 NCL 000670 VBL LINELENGTH VAL "35"
NNM1921 NCL 000670 VBL DAYS VAL "29"
NNM1921 NCL 000670 VBL DAY VAL "2"
NNM1921 NCL 000670 VBL FIRST VAL "7"
DEBUG MODIFY V=LINELENGTH VAL=5
NNM1932 NCL 000670 VBL LINELENGTH UPDATED
DEBUG DISPLAY V=LINELENGTH
NNM1921 NCL 000670 VBL LINELENGTH VAL "5"
DEBUG CLEAR BREAKPOINT=2
NNM1916 NCL 000670 BREAKPOINT 2 CLEARED
DEBUG RESUME
NNM1905 NCL 000670 RESUMED
NNM1936 NCL 000670 VBL LINELENGTH WRITE ACCESS
NNM1902 NCL 000670 SUSPENDED AT ZEX0904N.47 LINE 55
---------- ------------------ NonStop NET/MASTER D30 ---------------- --------
M=>