NET/MASTER Network Control Language (NCL) Programmer's Guide

The Standard Map $SPI
Standard and User-Defined Maps
106160 Tandem Computers Incorporated 11–21
7. Execute the following commands to ensure that NonStop NET/MASTER MS can
receive EMS messages:
EMSDIST START
EMSCOLL START
The EMSDIST START command starts the EMS distributor interface. The
EMSCOLL START command starts the EMS collector interface. You can use the
STATUS command to confirm that the interfaces have started.
8. Execute the following commands to ensure that your OCS profile allows you to
receive EMS and unsolicited messages:
PROFILE EMS=YES UNSOL=YES MONMSG=YES
9. Execute ZEX1103N from the OCS command input line by using the following
command:
START ZEX1103N
10. Observe the results of installing ZEX1102N as your active MSGPROC procedure
and executing ZEX1103N, as shown in the following two screens:
Screen 1 of 2.
(08:11) --------------------- OPERATOR CONTROL SERVICES ----------------------
START ZEX1103N
Sending a message to the EMS collector
NNM1005 START ZEX1103N PROCESSING COMPLETE. NCLID 001072
08:11:45 NNM9999 TEST Hello world from NMTJN
Elements under &$MSG.SPI.TANDEM are
ZSPI_TKN_HDRTYPE is 1
ZSPI_TKN_CHECKSUM is 0
ZSPI_TKN_LASTERR is
ZSPI_TKN_LASTERRCODE is .. d
ZSPI_TKN_MAX_FIELD_VERSION is 0
ZSPI_TKN_SSID is TANDEM.NNM.D30
ZSPI_TKN_USEDLEN is 127
ZSPI_TKN_BUFLEN is 127
ZEMS_TKN_CONSOLE_PRINT is 0
ZEMS_TKN_CPU is 3
ZEMS_TKN_CRTPID is $I003 3,130
ZEMS_TKN_EMPHASIS is 0
ZEMS_TKN_EVENTNUMBER is
ZEMS_TKN_FORWARDED is 0
ZEMS_TKN_GENTIME is 1992/06/14 22:11:44.602
ZEMS_TKN_LOGTIME is 1992/06/14 22:11:44.613
AUTO HOLD ------------------ NonStop NET/MASTER D30 ---------------- --------
M=>