NET/MASTER Network Control Language (NCL) Programmer's Guide

Getting Started With NCL Procedures
An NCL Tutorial
3–6 106160 Tandem Computers Incorporated
Step 2
Type the file name of the new NCL procedure. This is also the name of a new TEDIT
file.
When you enter Edit Services, your cursor is positioned after the File Spec: prompt.
Type the file name, HELLO1, after the File Spec: prompt, as shown in the following
screen, and then press the ENTER key:
------------------------- Edit Services : Selection List ----------------------
File Spec: HELLO1
Subvolume: $DATA9.MYNCLLIB
T=Test a panel S/B=Browse C=Compile D=Delete E=Edit
Filename Code EOF Last Modification Owner RWEP
F3=Exit F7=Prev F8=Next F11=Error List
You can type HELLO1 in either uppercase or lowercase. The case is not significant in
a file name. When you press the ENTER key after typing the name of the new NCL
procedure, you invoke TEDIT.
Since this is your first NCL procedure, the Edit Services selection list screen does not
display any NCL procedure names when you enter Edit Services. This section does
not describe in detail the components of the Edit Services selection list screen; the
components are described in the NonStop NET/MASTER MS Operator’s Guide.