NET/MASTER Network Control Language (NCL) Programmer's Guide

ManualsBrandsHP ManualsServerHP NonStop G-Series

771

772

773

774

775

776

777

778

779

780

Sending a Message to EMSPROC

Developing System-Level NCL Procedures

17–26 106160 Tandem Computers Incorporated

Finally, observe the results of installing ZEX1707N as your active MSGPROC

procedure and executing ZEX1709N, as shown in the following two screens:

Screen 1 of 2.

(14:42) --------------------- OPERATOR CONTROL SERVICES ----------------------

START ZEX1709N

Sending a message to the EMS collector

NNM1005 START ZEX1709N PROCESSING COMPLETE. NCLID 000025

14:42:28 NNM9999 TEST This is the &ABC.SPI.TANDEM.ZEMS_TKN_TEXT text

&$MSG.TEXT is NNM9999 TEST This is the &ABC.SPI.TANDEM.ZEMS_TKN_TEXT text

&$MSG.SPI.TANDEM.ZEMS_TKN_EVENTNUMBER.# is 9999

Elements under &$MSG.SPI.TANDEM are

ZSPI_TKN_HDRTYPE is 1

ZSPI_TKN_CHECKSUM is 0

ZSPI_TKN_LASTERR is

ZSPI_TKN_LASTERRCODE is .. d

ZSPI_TKN_MAX_FIELD_VERSION is 0

ZSPI_TKN_SSID is TANDEM.NNM.D30

ZSPI_TKN_USEDLEN is 151

ZSPI_TKN_BUFLEN is 151

ZEMS_TKN_CONSOLE_PRINT is 0

ZEMS_TKN_CPU is 3

ZEMS_TKN_CRTPID is $I003 3,121

ZEMS_TKN_EMPHASIS is 0

ZEMS_TKN_EVENTNUMBER is

ZEMS_TKN_FORWARDED is 0

AUTO HOLD ------------------ NonStop NET/MASTER D30 ---------------- --------

M=>

Screen 2 of 2.

(14:42) --------------------- OPERATOR CONTROL SERVICES ----------------------

ZEMS_TKN_GENTIME is 1992/06/18 04:42:28.023

ZEMS_TKN_LOGTIME is 1992/06/18 04:42:28.062

ZEMS_TKN_PIN is 121

ZEMS_TKN_REDUNDANT is 0

ZEMS_TKN_SUPPRESS_DISPLAY is 0

ZEMS_TKN_SYSTEM is 250

ZEMS_TKN_USERID is d.

ZEMS_TKN_NODENAME is \SYS1

ZEMS_TKN_SUBJECT_MARK is TANDEM.ZEMS_TKN_TEXT{1}

ZEMS_TKN_TEXT is TEST This is the &ABC.SPI.TANDEM.ZEMS_TKN_TEXT text

_____________________________________________________________________________