NET/MASTER RMS Management and Operations Guide

Adding a Message Action Rule
Creating and Developing Rulesets and Rules
115415 NonStop NET/MASTER RMS Management and Operations Guide 5–23
Using the Message Source
You can restrict the messages that can trigger the rule by specifying the source of the
messages (page 1 of the message action rule definition panels). You identify the source
by the following:
Domain ID of the NonStop NET/MASTER MS or the SOLVE management
services system from which the message comes
Name of the process that sends the message
044
MESSAGE SOURCE
--------------
Domain ID .........
Process Name ......
Generic terms ( * ) and wildcards ( ? ) accepted
Figure 5-3 shows a message that satisfies the condition in which the domain ID is
SDPL and the process name is \HERST.$Z100.
Figure 5-3. Message Source Criteria
\HERST
$Z100
NonStop
NET/MASTER
MS With Domain
ID SDPL
\SYS
$Z200
$ZNNM
1
1
2
• At 1, messages from $Z100 satisfy the condition in which the process name is \HERST.$Z100.
• At 2, messages from $Z100 satisfy the condition in which the process name is \HERST.$Z100 and the
domain ID is SDPL.
Intervening
Systems
2
009
Specifying the Domain ID. Use the domain ID as a criterion by specifying a value in the
Domain ID field (for example, SDPL). The field accepts up to 32 characters. Use the
wild-card characters, question mark (?) and asterisk (*), to match multiple domains.