NET/MASTER RMS Management and Operations Guide

Developing Command Groups
Updating and Maintaining Rulesets, Rules, and Command Groups
6–16 115415 NonStop NET/MASTER RMS Management and Operations Guide
a. Specify ALL in the Ruleset field.
b. Select option 4 to access Command Groups Maintenance. A selection list
panel appears listing all the command groups in RMS.
2. Type CP next to the names of the command groups to copy. Press ENTER to start
copying the command groups. An inset appears prompting for the name of the
ruleset to copy to.
a. Specify the name of the ruleset in the RULESET NAME field.
b. Specify N (NO, do not replace if the command group already exists) or Y (YES,
replace if the command group already exists) in the REPLACE field. The
default is N.
c. Press ENTER to start copying the command groups. RMS copies the
command groups in the order of the displayed list. A command group is
flagged as **COPIED** if the operation is successful.
3. Update the ruleset comments, as described in “Maintaining Comments,” later in
this section.
Modifying a Command
Group
You can modify any existing command group. You cannot, however, change the
command group ID. Modify a command group as follows:
1. At any => prompt, type =R.6 and press ENTER to access Rule Maintenance. The
RMS : Rule Maintenance panel appears.
a. Specify the name of the ruleset that contains the command group to modify in
the Ruleset field. If you wish to be prompted by a selection list panel, ensure
that the field is blank.
b. Select option 4 to access Command Groups Maintenance. If a selection list
panel appears, select the appropriate ruleset by typing an S next to the name
of the ruleset and pressing ENTER. The RMS : Command Groups
Maintenance panel appears.
2. At the Selection Key field, you can request a list of some or all of the command
groups in the ruleset as follows:
If you want a particular command group, specify the name of the command
group.
If you want a partial list, specify a partial text string (that is, the first few
characters of the name of a command group or command groups). RMS lists
the command groups in the ruleset that have names starting with the partial
text string in alphabetic order.
If you want a full list, leave the field blank. RMS lists all the command groups
in the ruleset.
Select option 2 to access Display/Modify/Delete/Add With Model. A selection
list panel appears.