NET/MASTER RMS Management and Operations Guide

Copying a Ruleset
Updating and Maintaining Rulesets, Rules, and Command Groups
6–18 115415 NonStop NET/MASTER RMS Management and Operations Guide
If you want a full list, leave the field blank. RMS lists all the command groups
in the ruleset.
Select option 2 to access Display/Modify/Delete/Add With Model.
3. On the selection list panel that appears, type a D next to the names of the
command groups to delete. Press ENTER. A message appears prompting you to
confirm the deletion.
Note If you change your mind and do not want to delete the selected command groups, cancel the delete
operation by pressing F12 and do not perform Steps 4 and 5.
4. Press ENTER to confirm the deletion. A command group is flagged as
**DELETED** if the operation is successful.
5. Update the ruleset comments to reflect the change to the ruleset, as described in
“Maintaining Comments,” later in this section.
Copying a Ruleset You can create a new ruleset by copying an existing ruleset and modifying the copy.
For example, you may want to create a ruleset that is slightly different from an existing
ruleset. RMS does not copy the control options record to the new ruleset; RMS creates
the control options record for the new ruleset using defaults. Figure 6-4 shows the
panels encountered when copying a ruleset.