NET/MASTER RMS Management and Operations Guide

Merging Rulesets
Updating and Maintaining Rulesets, Rules, and Command Groups
115415 NonStop NET/MASTER RMS Management and Operations Guide 6–23
Merge two rulesets as follows:
1. At any => prompt, type =R.5 and press ENTER to access Ruleset Maintenance.
The RMS : Ruleset Maintenance panel appears.
SDPL--------------------- RMS : Ruleset Maintenance -------------------ZRMSRSMP
Select Option ===>
1 - Create Ruleset
2 - Copy Ruleset
3 - Merge Rulesets
4 - Delete Ruleset
5 - Transfer Ruleset
9 - Ruleset Report Functions
X - Exit
Ruleset ................ ˚˚˚˚˚˚˚ (Ruleset name, BLANK for Selection List)
( Ignored for option 5)
F1=Help F2=Split F3=Exit F4=Return F9=Swap
a. Specify the name of the source ruleset in the Ruleset field. You can leave the
field blank if you wish to be prompted by a selection list panel.
b. Select option 3 to access Merge Rulesets. If a selection list panel appears, select
the required source ruleset by typing an S next to the name of the ruleset and
pressing ENTER. The RMS : Ruleset Merge panel appears.
Note If you change your mind and do not want to merge the rulesets, cancel the merge operation by pressing
F12 and do not perform Steps 2 and 3.
2. Specify the name of the target ruleset and press ENTER to start merging the
rulesets. Messages appear advising you of the progress of the merge operation.
Once the operation is complete, the RMS : Ruleset Maintenance panel reappears,
and a message confirms that the appropriate rules and command groups from the
source ruleset are merged into the target ruleset.
3. Update the comments on the ruleset, as described in “Maintaining Comments,”
later in this section.
You have an expanded ruleset. You can make further changes to the ruleset to suit
your requirements; remember to update the comments as you do so.