NET/MASTER RMS Management and Operations Guide

Testing Time-Based Rules
Testing Rules Using Simulated Events
115415 NonStop NET/MASTER RMS Management and Operations Guide 8–17
Testing Time-Based
Rules
You can simulate a specific time or a time range to test which time-based rules in a
ruleset satisfy the time criteria. You can interactively change the rules in the ruleset
and the simulated time. Figure 8-5 shows the panels encountered when simulating a
time to test a ruleset.
Simulate a specific time or a time range to test the time-based rules in a ruleset as
follows:
1. At any => prompt, type =R.7 and press ENTER to access Event Simulation. The
RMS : Event Simulation panel appears.
a. At the Ruleset field, specify the name of the ruleset to test. If you wish to be
prompted by a selection list panel, ensure that the field is blank.
b. Select option 2 to access Timer Activation Simulation. If a selection list panel
appears, select the appropriate ruleset by typing an S next to the name of the
ruleset and pressing ENTER. The RMS : Event Simulation—Time-Based Rules
panel appears.
SDPL----------- RMS : Event Simulation - Time-Based Rules -------------ZRMSES2P
Command ===>
CLOCK SETTINGS (Set simulation day/date and time)
Time1 ... ˚˚˚˚˚˚˚ (HH:MM:SS - Activation time or range start)
Time2 ... ˚˚˚˚˚˚˚ (HH:MM:SS - Range end or blank)
Day ..... ˚˚˚˚˚˚˚ (MON,TUE,...)
Date .... ˚˚˚˚˚˚˚ (YY/MM/DD - optional)
F1=Help F2=Split F3=File F9=Swap F12=Cancel