NET/MASTER RMS Management and Operations Guide

Controlling Message Handlers
Controlling Message Handlers and Rules
9–8 115415 NonStop NET/MASTER RMS Management and Operations Guide
Displaying the List of
Message Handlers and
Their Descriptions
You can display the list of message handlers by selecting option 2 from the NonStop
NET/MASTER RMS primary menu panel. The RMS : Active Message Handlers panel
appears and provides the following information on the handlers:
Column Head Description
NCL ID Identifies the NCL process that is the message handler.
Type Identifies the type of the message handler.
Region Identifies the owner of the environment or region in which the message handler is
executing.
Ruleset Identifies the rulesets that the message handler is using.
SDPL------------------- RMS : Active Message Handlers -----------------ZRMSMHCP
Command ===> Scroll ===> PAGE
S=Select P=Purge
NCL ID Type Region Ruleset
000009 INT NMTHY HYRLST01
000012 MSG NMTHY STATSCAP
002000 EMS SDPLEMSP BASERULE
*END*
F1=Help F2=Split F3=Exit F4=Return F6=Refresh
F7=Backward F8=Forward F9=Swap F11=Right
Explicitly Purging Message
Handlers by Using the RMS
Panel Interface
You can explicitly purge executing message handlers by using the RMS panel interface
as follows:
1. From the NonStop NET/MASTER RMS primary menu panel, select option 2 to
access Active Message Handler Control. The RMS : Active Message Handlers
panel appears.
2. Type a P next to the NCL IDs of the message handlers to purge and press ENTER.
A message appears prompting you to confirm the purge of the handlers.
Note If you change your mind and want to cancel the purging operation, press F12 and do not perform Step 3.
3. Press ENTER to start purging the handlers. A handler is flagged as **STOPPED**
if the operation is successful.