Manualshelf

NET/MASTER RMS Management and Operations Guide

ManualsBrandsHP ManualsServerHP NonStop G-Series
321322323324325326327328329330
RMS0030
RMS Messages
A–10 115415 NonStop NET/MASTER RMS Management and Operations Guide
Recovery. Change the invalid value to a positive integer before requesting the action
again.
RMS0030 INVALID SUBMIT ACTION VALUE
Cause. You specified an invalid value in the Submit Actions field on your data entry
panel. This panel could be the System Action panel (page 5 of the message action rule
definition panels), or the System Action panel (page 3 of the message group rule
definition panels).
Effect. The value is not accepted. The action is not performed.
Recovery. Change the invalid value to one of the following regions: BMON, BSYS,
BLOG, LOGP, or EMSP. System actions will be performed in the specified region. If
the field is left blank, the specified system actions will be executed in the same region
as the message handler.
RMS0031 INVALID DOMAIN ID
Cause. You specified an invalid value in the Domain ID field on your data entry panel
(for example, page 1 of the message action rule definition panels).
Effect. The value is not accepted. The action is not performed.
Recovery. Change the invalid value to a valid domain ID before requesting the action
again. A valid domain ID can contain up to four characters: the first character must be
alphabetic; the rest must consist of alphanumeric, @, #, and $ characters.
RMS0032 ONLY ONE S(ELECTION) MAY BE MADE ON THIS SELECTION LIST
Cause. You selected more than one item on a selection list panel that allows only one
item to be selected. An example is the Ruleset Selection panel.
Effect. The selections are not accepted. The selections, as indicated by the S (Select)
action codes, are highlighted.
Recovery. Erase all the highlighted action codes except the one beside the item you
want and press ENTER to select it.
RMS0033 MUST BE ALPHANUMERIC, @, #, OR $
Cause. You specified an invalid value in a field on your panel. The field requires a
value that contains only alphanumeric, @, #, and $ characters.
Effect. The value is not accepted. The action is not performed.