NET/MASTER RMS Management and Operations Guide

RMS1104
RMS Messages
115415 NonStop NET/MASTER RMS Management and Operations Guide A–39
Effect. If the Message Replacement setting is B, the replacement by and the delivery of
the multiline message are carried out.
If the Message Replacement setting is S, then this narrative message only describes the
action that would have been performed—either the original message is delivered and
no replacement takes place (message action rule), or no message is delivered (message
group rule).
Recovery. This message is informational only; no recovery action is necessary.
RMS1104 *** color-attribute hlite-attribute intens-attribute
alarm-attribute nrd-attribute scan-attribute mon-attribute
msg-code-attribute
Cause. A message triggered a message action rule or a group of messages triggered a
message group rule that requested the delivery of a multiline message (replacing the
triggering message if this is a message action rule).
This narrative message advises that the multiline message will have the noted message
attributes (these are the attributes that you specified on the Message Modification
panel during the definition of a message action rule, or on the Message Parameters
panel during the definition of a message group rule). The Message Replacement
control option of the ruleset used is set to B or S to narrate these attributes. Whether
the replacement by and the delivery of the multiline message are actually carried out
depends on this setting.
Only the message attributes that are set in the rule definition appear in the message.
Possible values of the attributes are as follows:
color-attribute COLOR={ BLUE | GREEN | PINK | RED | TURQUOISE
| WHITE | YELLOW }
hlite-attribute HLITE={ USCORE | BLINK | REVERSE }
intens-attribute INTENS={ HIGH | LOW }
alarm-attribute ALARM={ YES | NO }
nrd-attribute NRD={ YES | NO }
scan-attribute SCAN={ YES | NO }
mon-attribute MON={ YES | NO }
msg-code-attribute MSGCODE=xx
Effect. If the Message Replacement setting is B, these message attributes are set to the
given values for the multiline message.
If the Message Replacement setting is S, then this narrative message only describes the
action that would have been performed—no attributes are modified or set.
Recovery. This message is informational only; no recovery action is necessary.