NET/MASTER RMS Management and Operations Guide

RMS1116
RMS Messages
A–44 115415 NonStop NET/MASTER RMS Management and Operations Guide
This narrative message describes the action of issuing the command (this is the
command that you specified as INTCMD command-text in the Command Text field on
the rule definition panels or in a command group that was used in the rule). The
NonStop NET/MASTER Command control option of the ruleset used (and the Exec
Command Group control option if the command was issued through a command
group) is set to B or S to narrate this action. Whether the command is actually issued
depends on this setting.
Effect. If the NonStop NET/MASTER Command setting is B, the command specified
in the rule is issued and command-text is executed in the dependent processing
environment.
If the NonStop NET/MASTER Command setting is S, then this narrative message only
describes the action that would have been performed—the command is not issued.
Recovery. This message is informational only; no recovery action is necessary.
RMS1116 *** RULESET( ruleset-name ) RULE( rule-id ) START AN NCL PROCEDURE
Cause. A message triggered a message action rule, or a group of messages triggered a
message group rule, or a time event triggered a timer that is based on a time-based
rule, that requested the starting of an NCL procedure for asynchronous execution.
rule-id is the name of the rule, and ruleset-name is the name of the ruleset that
contains the rule.
This narrative message describes the action of starting the NCL procedure (this is the
NCL procedure that you specified in the NCL Proc Name field on the rule definition
panels). The Start NCL Procedure control option of the ruleset used is set to B or S to
narrate this action. Whether the NCL procedure is actually started depends on this
setting.
Effect. If the Start NCL Procedure setting is B, the NCL procedure specified in the rule
is started.
If the Start NCL Procedure setting is S, then this narrative message only describes the
action that would have been performed—the NCL procedure is not started.
Recovery. This message is informational only; no recovery action is necessary.
RMS1117 *** RULESET( ruleset-name ) RULE( rule-id ) EXECUTE A COMMAND
GROUP
Cause. A message triggered a message action rule, or a group of messages triggered a
message group rule, or a time event triggered a timer that is based on a time-based
rule, that requested the execution of a command group. rule-id is the name of the
rule, and ruleset-name is the name of the ruleset that contains the rule.