NET/MASTER RMS Management and Operations Guide

RMS1119
RMS Messages
115415 NonStop NET/MASTER RMS Management and Operations Guide A–45
This narrative message describes the action of executing the command group (this is
the command group that you specified in the Exec Cmd Group field on the rule
definition panels). The Exec Command Group control option of the ruleset used is set
to B or S to narrate this action. Whether the command group is actually executed
depends on this setting.
Effect. If the Exec Command Group setting is B, the command group specified in the
rule is executed.
If the Exec Command Group setting is S, then this narrative message only describes
the action that would have been performed—the command group is not executed.
Recovery. This message is informational only; no recovery action is necessary.
RMS1118 *** RULESET( ruleset-name ) RULE( rule-id ) ACTIVATE A TIMER
Cause. A message triggered a message action rule or a group of messages triggered a
message group rule that requested the activation of a timer. rule-id is the name of
the triggered rule, and ruleset-name is the name of the ruleset that contains the
rule.
This narrative message describes the action of activating the timer (the timer will be
activated according to the time-based rule that you specified in the Activate Timer
field on the rule definition panels). The Activate Timer control option of the ruleset
used is set to B or S to narrate this action. Whether the timer is actually activated
depends on this setting.
Effect. If the Activate Timer control option setting is B, the timer is activated according
to the specified time-based rule, changing the status of the time-based rule from
PENDING to ACTIVE.
If the Activate Timer control option setting is S, then this narrative message only
describes the action that would have been performed—the timer is not activated.
Recovery. This message is informational only; no recovery action is necessary.
RMS1119 *** command-text
Cause. This narrative message describes the action of issuing a NonStop
NET/MASTER MS command. command-text is the text of the issued command. If
this is an OPSYS or PROGRUN command, then the System Command control option
of the ruleset used is set to B or S to narrate this action. If this is any other NonStop
NET/MASTER MS command, then the NonStop NET/MASTER Command control
option of the ruleset used is set to B or S to narrate this action. Whether the command
is actually issued depends on the related setting.