NET/MASTER RMS Management and Operations Guide

RMS1120
RMS Messages
A–46 115415 NonStop NET/MASTER RMS Management and Operations Guide
The message could appear as a result of a message action rule or a message group rule
or a time-based rule being triggered, and either this command is specified in the
Command Text field of the rule definition or this command is part of a Command
Group specified in the Exec Cmd Group field of the rule definition.
Effect. If the related control option setting is B, the command specified by
command-text is issued.
If the control option setting is S, then this narrative message only describes the action
that would have been performed—the command is not issued.
Recovery. This message is informational only; no recovery action is necessary.
RMS1120 *** RULESET( ruleset-name ) RULE( rule-id ) handler-type CONT
color-attribute hlite-attribute intens-attribute
alarm-attribute nrd-attribute scan-attribute mon-attribute
msg-code-attribute
Cause. A message triggered a message action rule that requested the modification of
the attributes of the message before delivery. rule-id is the name of the triggered
rule, and ruleset-name is the name of the ruleset that contains the rule.
The message handler sent this narrative message to describe the action of modifying
the attributes of the triggering message before delivery (these are the attributes that
you specified on the Message Modification panel). The Message Modification control
option of the ruleset used is set to B or S to narrate this action. Whether the message
handler actually delivers the message with the modified attributes depends on this
setting.
The message is delivered according to the message handler type handler-type as
follows:
EMS Message is delivered using the EMSCONT verb.
LOG Message is delivered using the LOGCONT verb.
MSG Message is delivered using the MSGCONT verb.
INT Message is delivered using the INTCONT verb.
Only the message attributes that are set in the rule definition appear in the message.
Possible values of the attributes are as follows:
color-attribute COLOR={ BLUE | GREEN | PINK | RED | TURQUOISE
| WHITE | YELLOW }
hlite-attribute HLITE={ USCORE | BLINK | REVERSE }
intens-attribute INTENS={ HIGH | LOW }
alarm-attribute ALARM={ YES | NO }
nrd-attribute NRD={ YES | NO }
scan-attribute SCAN={ YES | NO }