NET/MASTER RMS Management and Operations Guide

RMS3000
RMS Messages
115415 NonStop NET/MASTER RMS Management and Operations Guide A–53
RMS2001 ANOTHER USER IS ACCESSING THIS MSG HANDLER, TRY AGAIN LATER
Cause. You typed the S (Select) or P (Purge) action code next to a message handler on
your Active Message Handlers panel and pressed ENTER, but another user was
already operating on that message handler.
Effect. The message handler is not selected or purged.
Recovery. Wait a few minutes, then press F6 to refresh your panel. Repeat the
procedure if the message handler is still listed.
RMS2002 ENTER TO CONFIRM MSG HANDLER STOP OR F12 TO CANCEL
Cause. You typed the P (Purge) action code next to one or more of the message
handlers on your Active Message Handlers panel and pressed ENTER. This action
requires your confirmation.
Effect. The actions requiring confirmation are highlighted.
Recovery. Press ENTER to confirm the action, or F12 to cancel it.
RMS2004 NOT ALLOWED TO FLUSH - MSGPROC NOT IN YOUR REGION
Cause. You typed the P (Purge) action code next to a message handler of type MSG on
your Active Message Handlers panel and pressed ENTER. The MSGPROC is not
executing in your window. You can only purge a MSGPROC that is executing in your
current window.
Effect. The selected MSGPROC is not purged.
Recovery. This message is informational only; no recovery action is necessary. If you
want to purge the MSGPROC, go to the OCS window in which the MSGPROC is
executing and issue the PROFILE MSGPROC=FLUSH command.
RMS3000 TIMER DRIVER NOT ACTIVE
Cause. You selected option 3 (Active RMS Timer Control) on your NonStop
NET/MASTER RMS primary menu panel to access the list of active timers, but the
RMS timer driver NCL procedure was not executing and all timer related activities
could not be performed. Possible causes are as follows:
Some error, which may have occurred previous to the selection of this option, has
caused the timer driver to terminate.